Registered Sheet Metal Contractor
- Exam
- Not reported
- Education
- Not reported
- Experience
- Not reported
- Background check
- Not reported
Florida Chapter 489. A “sheet metal contractor” means a contractor whose services are unlimited in the sheet metal trade and who has the experience and skill necessary for the manufacture, fabrication, assembling, handling, erection, installation, dismantling, conditioning, adjustment, insulation, alteration, repair, servicing, or design of ferrous or nonferrous metal work of U.S. No. 10 gauge or its equivalent or lighter gauge. A sheet metal contractor may also work with other materials, including, but not limited to, fiberglass.
What this record tells you
Florida reports the Registered Sheet Metal Contractor with a status of "Active" and a licence type of "Stand-alone license".
The issuing body named in the record is Division of Professions.
The state report does not specify exam, education, or experience requirements.
The record was last updated before 2022, so confirm the details with the board.
Requirements reported by the state
- Licence type
- Stand-alone license
Issuing body
- Department
- FL Dept. of Business and Professional Regulation
- Division
- Division of Professions
- Address
- 1940 N. Monroe Street Tallahassee, FL 32399
- Phone
- (850) 487-1395
- Agency website
- www.myfloridalicense.com/dbpr/
- Last updated
- February 25, 2020
Occupations (O*NET)
- Apprentice, Registered (Construction Trades) 47-2211.00
Source and verification
This record is Florida's report to the Analyst Resource Center, published by CareerOneStop (October 2024 export). Everything shown comes only from that report.
Before you apply, confirm every detail with Division of Professions — see the issuing body section above.
How we process this data. Not legal advice.